Raymarine AIS700 Class B AIS Data Transceiver with Splitter E70476 RYE70476

Raymarine AIS700 Class B AIS Data Transceiver with Splitter

The AIS700 from Raymarine is a Class B Automatic Identification System (AIS) transceiver designed for use with Raymarine multifunction navigation display systems. As a Class B AIS transceiver, the AIS700 not only receives broadcasts from other vessels, it also transmits your own boat’s information too helping you to be seen on other vessels’ systems.
•    Full transmit and receive AIS for enhanced situational awareness and safety.
•    Latest SO-TDMA networking for longer range and faster performance.
•    Built-in antenna splitter simplifies installation with existing VHF radio antenna.
•    NMEA2000, NMEA0183, PC (setup & diagnostics) and SeaTalkng compatible.
•    Software or hardware switchable Silent Mode for enhanced security when needed.

Maximum visibility
Operating in the VHF maritime band, the Raymarine AIS system enables the wireless exchange of navigation status between vessels and shore-side traffic monitoring centres. Commercial ships, ocean-going vessels and recreational boats equipped with Raymarine AIS transmitters broadcast AIS messages that include the vessel's name, course, speed and current navigation status.

ENVIRONMENTAL SPECIFICATIONS
Operating temperature: -15°C to +55°C;
Storage temperature: -20°C to +75°C;
Water ingress: IPX6 and IPX7;
Humidity: Up to 93% @ 40°C.
POWER SPECIFICATIONS
Power Supply: 12v and 24 nominal;
Power Consumption: <3W;
Peak current: 3A;
Load Equivalency Number: 1 LEN.
RF SPECIFICATIONS
DSC Receiver: Implemented by time sharing with one TDMA receiver;
Receiver 1 band: 156.025 MHz to 162.025 MHz (in 25KHz steps);
Receiver 2 band: 156.025 MHz to 162.025 MHz (in 25KHz steps);
Transmitter band: 156.025 MHz to 162.025 MHz (in 25KHz steps);
Transmitter specification: To meet IEC 62287-2 relevant sections;
Receiver specification: To meet IEC 62287-2 relevant sections;
Transceiver specification: To meet IEC 62287-2 relevant sections;
GPS receiver: u-blox MAX-M8W;
GPS receiver channels: 72 channels;
GPS Cold start acquisition time: 26s nominal;
Positional source: GPS & GLONASS;
AIS performance: 5W SOTDMA.
ANTENNA SPLITTER SPECIFICATIONS
Operating frequency range:
- 156.0MHz to 162.025MHz Transmitting;
- 156.0MHz to 162.025MHz Receiving;
Insertion loss AIS RX path: 0dB;
Insertion loss AIS TX path: <1dB;
Insertion loss VHF RX path: 0dB;
Insertion loss VHF TX path: <1dB;
Power handling AIS port: Maximum 5W input;
Power handling VHF port: 25W input;
Switching time RX to VHF TX: 10uS Max;
Switching time RX to AIS TX: 10uS Max;
Switching time VHF TX to AIS TX: 10uS Max;
Switching time any TX to RX: 10uS Max;
VHF port impedance: 50 Ohms;
AIS port impedance: 50 Ohms;
Antenna port impedance: 50 Ohms;
VHF to AIS port isolation: >28dB (both directions);
Minimum VHF input power for switching: 400mW.
EXTERNAL CONNECTIONS
VHF antenna connector type: SO-239 co-axial
VHF radio connector type: SO-239 co-axial
GNSS antenna connector : 50Ω TNC co-axial
NMEA2000: DeviceNet male
USB: Micro-B
External interface isolation: NMEA0183 and NMEA 2000 interfaces to incorporate galvanic isolation from power supply as required by the relevant interface specification;
NMEA0183 interface 1 (MFD connection): NMEA 0183 HS (IEC 61162-1) compliant, bi-directional, RS422 levels. 4 wire interface (differential signalling). Configurable baud rate. Input to MFD from AIS;
NMEA0183 interface 2 (NMEA0183 instrument connection): NMEA 0183 (IEC 61162-1) compliant, bi-directional, RS422 levels. 4 wire interface (differential signalling). 4 wire interface (differential signalling) Configurable baud rate;
USB interface (PC connection): Protocol NMEA 0183 HS (IEC 61162-1) compliant, bi-directional USB port, 38.4 kBaud.

IN THE BOX:
1 - AIS700 Class B AIS Transceiver with built-in VHF antenna splitter;
2 - GNSS (GPS) Antenna with captive cable 10m (33 ft);
3 - Power / data cable 2m (6.56 ft);
4 - VHF Radio cable 1m (3.28 ft);
5 - DeviceNet to SeaTalkng® adaptor cable 1m (3.28 ft);
6 - GNSS antenna gasket;
7 - GNSS antenna pole mount;
8 - Unit fixings (4 x No.8x19 self tapping screws);
9 - M5 nut and washer (grounding);
10 - Documentation kit;
11 - GNSS antenna fixings (3 x M3x40 stud and thumb nut);
12 - Software CD.

Raymarine E70476