Boero Altura UV Glossy Varnish 0,375 Lt 45100600

Boero Altura UV Glossy Varnish, 0,375lt.

Clear synthetic varnish. It is resistant to environmental marine factors and UV rays.

PHYSICAL ASPECTS (at 20° C)
Aspect: Glossy
Colour: Colourless
Volume solid %: 54 ± 2 %
Specific weight: 0,92 ÷ 0,96 g/cm³
Flash point: 30° C
Viscosity: 70 ÷ 80” DIN 4 at 20°C

APPLICATION DETAILS
Thinner: 703.000
Application Method
Conventional: Pressure: 3,5 bar Nozzle diameter: 1,2 – 1,4 mm
Dry film thickness: Standard range of application 30 μ (Recommended 30 μ)
Wet film thickness: Standard range of application 60 μ (Recommended 60 μ)
Theoretical coverage m2/litre: Range of application at recommended thickness 16

Primers recommended: Biowood - Polywood

SURFACE PREPARATION
New or renovated wood: wood must be perfectly dry and free from any trace of dirt, grease, dust and previous varnishes; apply a first coat of ALTURA UV thinned at 5 - 10%. Proceed with subsequent coats (3 - 5 ) undiluted. 

Painted wood: sand to eliminate traces of previous varnishes. Apply one coat ofi ALTURA UV thinned at 2%, and proceed with subsequent coats ( 2 - 4 ) undiluted. NOTE: Sand between the layers.

APPLICATION CONDITIONS
To avoid the formation of condensation, the temperature of the surface should be at least 3 °C above dew point. During the application and curing the min. ambient temperature should be 15 °C, or higher than 30° C; substrate temperature must not be lower than 10° C since curing is reduced at lower temperatures. Application is not advisable when relative humidity exceeds 80%. The thermo-hygrometric survey should be carried out near the surface to be coated. It is important to be sure there is sufficient ventilation when the application takes place in closed areas.

SAFETY RULES
In order to protect personal health it is advisable to comply with the EU DPR 303 and 547 regulations. Avoid, for example any contact of the product with the skin and eyes. Use in well ventilated areas,in enclosed areas use aspirators, fans and air ventilators. Wear masks, goggles, gloves while applying the product.

NOTE
Ensure that the product does not come in contact with water, chemical products or undergoes mechanical stress before the curing is complete. The wet film thickness refers to an undiluted product. In case of dilution, this value increases.